 |
 |
|
| typical photos | specs for non-service entrance rated | specs for service entrance rated |
| Click thumbnail image above to enlarge | ||
Page last updated Jul 16, 2011 @ 12:18am
OTEC800
|
|
|
| typical photos | specs for non-service entrance rated | specs for service entrance rated |
| Click thumbnail image above to enlarge | ||
Automatic Transfer Switch
800 amp
with exerciser clock kit & charger
The OTEC Open Transition Transfer Switch provides dependable load transfer for emergency and standby applications. Featuring an easy-to-use microprocessor-based control panel, this switch provides reliable and cost-effective load transfer between a utility service and generator set.
Standard Features
* Open transition load transfer with selectable phase check or programmed transition.
* 3-phase voltage sensing on the normal source; single phase sensing on the generator.
* Front panel indicators and push buttons for ease of set-up.
* Simple-to-read control panel that features universal symbols for easy status recognition.
* Adjustable time delays.
* Integral exerciser clock.
* UL/NEMA 1 indoor enclosure.
* UL Listed and CSA Certified.Optional Features
* Service entrance rated disconnect
* Fully programmable exerciser clock.
* Elevator signal relay.
* Battery chargers.
* UL/NEMA 3R, 4, 12 enclosures.
Specs
| Switch Current Rating | 800 amps |
| Poles | 3 pole with solid neutral |
| Voltage Rating | 600Vac maximum |
| Transfer Time | 6 cycles max at 60Hz with nominal voltage applied to actuator (without delayed transition enabled) |
| Operating Temperature | -22F to +140F (-30C to +60C) |
| Operating Humidity | 95% relative humidity, non-condensing |
| Altitude | up to 10,000 feet without derating |
| Microprocessor Control |
- start time delay: 0-10 seconds adj. - transfer time delay: 0-300 seconds adj. - retransfer time delay: 0-30 minutes adj. - stop time delay: 0-30 minutes adj. - programmed transition 0-10 sec adj. - undervoltage sensing of normal source: pickup 90% to 95% of nominal adj. dropout 70% to 90% of nominal adj. dropout time delay: 0.1-1.0 seconds adj. - undervoltage sensing of generator: pickup 90% of nominal dropout 75% of nominal dropout time delay: 0.1-1.0 seconds adj. - frequency sensing of generator: pickup 90% of nominal dropout 75% of nominal |
| Options Included | - 2 amp battery charger |
| Other Options Available at additional cost (partial listing) |
- 40A, 70A, 125A, 150A, 225A,
260A, 300A, 400A, 600A, 800A, 1000A ratings - 120VAC through 600VAC - 4 pole with switched neutral - 50Hz - 3 phase 3 wire or 4 wire - type 3R, 4, 12 enclosures - service entrance rated disconnect (through 800A) |
| Lug Capacities Caution: Do not run control wiring through power cable conduit or raceway. |
(4) 250-500MCM |
| Enclosure | UL type 1 indoor (types 3R, 4, 12 optional) |
| Color | Cummins |
| Nominal Dimensions (H x W x D) | see spec sheet above |
| Weight | see spec sheet above |
NOTE:
This switch is available with service entrance rating as an optional adder. Without this option you normally will need a service entrance rated disconnect between this switch and your power company meter.
Item Number: OTEC800
Price: $6,263
Price last updated 1/3/2010
Shipping Weight: 360 lbs.
This item normally ships in approximately 4 weeks or less.
If not paying by credit card contact NoOutage before placing order.
Are YOU ready for the next power outage?
We welcome your feedback or questions. Click here to contact us.
See our Terms & Conditions before using information or
ordering from this web site.
Copyright © 1999-2012 NoOutage.com LLC. All rights reserved.
